A cupboard finish that is outdated gives a retro appearance, although perhaps not usually in a great manner to a kitchen. It’s possible for you to alter the tone of your cupboards — without the trouble of re-staining and stripping — by glazing above their present polyurethane finish. A glaze is actually a clear end with extra pigment that leaves it see-through. With the addition of colorant it’s possible for you to turn any obvious end right into a glaze, or you also can purchase a pre-combined glaze. Oil-based epoxy and polyurethane resin glazes function best on polyurethane. Use with attention. Because a glaze stays on the area where it’s exposed to scraping and chipping, it has to be long-lasting and stick nicely to the present finish.
Sand the cupboard with 120-grit sandpaper and wipe it down using a rag moistened with alcohol or acetone. Roughing up the area promotes adhesion of the glaze.
Add colorant incrementally into a pre-stirred can of polyurethane varnish to produce your personal glaze. It’s possible for you to make any wood tone with the addition of a mixture of the four major wood-tone pigments sienna and burnt and raw umber. If you’re feeling creative, you can even use primary-color pigments like blue, red and green to include an eyecatching clean of colour to oak or pine cupboards.
Spray on the glaze on the cupboard with the air sprayer or brush it using a paintbrush. Spraying creates a finish coat with defects that are less, but nevertheless, it could not be useful, particularly when you’re utilizing a glaze with the epoxy resin base. Many glazes that are made are resin-based. For those who do not need to spring for a sprayer, or need to brush it, use brush-strokes that are straight and brush gradually therefore the the final does not form bubbles.
Do not use the cupboards, close the blinds or block away them with a dropcloth to shield them from sun, moisture and dirt while the treatments. This could take from 2 4 to two days, according to the foundation finish.